The Muino water approach for water usage sensors aims to simplify installation by reducing complexity. Unlike traditional inductive sensors, the new design is smaller and easier to place, with a more intuitive interface. It also offers higher resolution, allowing for more accurate measurement of water usage, including smaller amounts sub 100-milimeter.
Version prototype
The muino sensor front version 1 also called the prototype
Version 2
This is the first version I made in production and sold on Tindie. I was sold-out after less than 2 months link Tindie store.
The muino sensor front version 2
Version 3
This version I order on high production level. For sale since first of November.
The muino sensor front version 3
3D case for version 3
This is a protective case for the sensor itself. Made by J. Mulder.
The muino sensor 3D case
Version DIY
This version is basically the watermeter above but than a sensor only board that you can controll by using I2C communication link Tindie store.
The muino sensor front version DIY
The muino sensor connected with a Raspberry pi Pico MCU